Diy: Sticky For Window Motor Repairs/door Panel Removal - Page 31 - - Infiniti G35 & G37 Forum Discussion | rupromenergo.ru
Show Your Support Become A Premier Member

    > >
  • Reload this Page >
    • Diy: Sticky For Window Motor Repairs/door Panel Removal


Diy: Sticky For Window Motor Repairs/door Panel Removal

Thread Tools Rating: Thread Rating: 6 votes, 5.00 average.
Old 07-23-2015, 03:49 PM
Registered User
Join Date: Dec 2014
Posts: 15
Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by j_mullet View Post
Hey there. I had a similar problem. My window would roll up, but its was jumpy when rolling down, or it would not roll down at all.
I cleaned up the motor, and put it back together. Seemed to be good, within one day the problem returned.
I took it apart a couple of days later, did another clean on the motor, then noticed the lubricant for the front trackbwas sticky. Used some brake cleaner to clean off the old lube, put some fresh grease and bobs your uncle! Works great going up and down now.
Thought I would share incase someone else can benefit. Also making sure cleaning where the armature seats into is cleaned is key as well. Good luck and thanks for the diy!!!
Update:
So shortly after this attempt it failed again. Took it apart again and the armature was gooped up again and so were the brushes. I decided to break it down further and see what's going on in the gear box.
Turns out there is this black tar type stuff I assume is used as a sealant. When I cleaned off the armature and brushes with some parts cleaner, I guess it leaked down and started to break down the black tar stuff, which in turn got on all the moving parts in the gear box. I cleaned as much of the black gunk off as I could, and swapped the drivers and passenger armatures. Since doing this, no problems with either window. The problem window now opens and closes faster than the one without issue. This fix cost me zero dollars, just a lot of time. If I would have broken it fully down the first time, would have been much quicker fix. Good luck to all, hope this helps!
Old 08-01-2015, 01:45 PM
Registered User
Join Date: Jul 2015
location: NJ
Posts: 41
Thanked 2 Times in 2 Posts
Hey guys; do you think this issue is caused by the tracks being gooped-up, or perhaps something else? I just replaced the dc brushes with the recommended factory-identical parts and the motor is plenty strong now.. still, when the window gets lower on the track is becomes very sluggish.
Thanks
Old 08-01-2015, 02:09 PM
Registered User
Join Date: Dec 2014
Posts: 15
Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by GringitoLoco View Post
Hey guys; do you think this issue is caused by the tracks being gooped-up, or perhaps something else? I just replaced the dc brushes with the recommended factory-identical parts and the motor is plenty strong now.. still, when the window gets lower on the track is becomes very sluggish.
Thanks
Where did you get the brushes?? Link?
Old 08-01-2015, 07:45 PM
Registered User
Join Date: Jul 2015
location: NJ
Posts: 41
Thanked 2 Times in 2 Posts
Quote:
Originally Posted by j_mullet View Post
Where did you get the brushes?? Link?
Yes sir,



These are exact replacements, same size and all, the only thing you need to do is lightly file a slight curvature on the brush heads so they make flash contact with the motor itself.

They're sold individually; you'll need 2 of these per motor.. 4 brushes for two motors.

Last edited by GringitoLoco; 08-02-2015 at 10:58 AM.
Old 08-10-2015, 06:57 PM
Registered User
iTrader: (4)
Join Date: Oct 2007
location: o-town & west palm beach FL
Posts: 5,266
Thanked 351 Times in 212 Posts
i got mine at an electronics/hobby store.. they were on clearance so i bought a bunch
Old 03-13-2016, 09:28 PM
Registered User
Join Date: Jan 2016
Posts: 82
Thanked 0 Times in 0 Posts
Used this post to assist me in changing out both of my motors today.

Was definitely more work then I thought it would be aligning the window with the tracks and keeping everything in place. But it worked out and I finally can cruise with my windows down lol.

Thanks a lot!
Old 07-11-2016, 01:18 PM
Registered User
Join Date: Jun 2016
Posts: 83
Thanked 3 Times in 3 Posts
my window motor just started acting up this week thank you for this diy i will put it too good use
Old 07-12-2016, 07:07 AM
Urbanengineer's Avatar
Registered User
iTrader: (2)
Join Date: Jun 2013
location: Pig Town, OHIO
Posts: 8,000
Thanked 632 Times in 598 Posts
Did anyone notice their window not dropping when opening the door as a premature sign of failure? My window won't drop down in the front driver, window raises and lowers well though.
Old 07-12-2016, 02:34 PM
Registered User
iTrader: (5)
Join Date: Apr 2009
Posts: 8,306
Thanked 469 Times in 416 Posts
if its an aftermarket motor my warranty exchanged motor from orielys did that. it wasnt failing going up and down just the open door feature. i kept it on for couple of months out of laziness and finally replaced it under the lifetime warranty. these refurb motors are sometimes hit and miss
Old 07-19-2016, 11:41 AM
g35man04's Avatar
CLUB MODERATOR
Thread Starter
iTrader: (280)
Join Date: Nov 2006
location: Denton, Texas
Posts: 12,976
Thanked 148 Times in 115 Posts
Quote:
Originally Posted by Urbanengineer View Post
Did anyone notice their window not dropping when opening the door as a premature sign of failure? My window won't drop down in the front driver, window raises and lowers well though.
probably needs to be reset or your motor depending on where you purchased it from could have bad limiter when they rebuilt it or the reset switch is completely stuck/seized.
Old 07-19-2016, 11:41 AM
g35man04's Avatar
CLUB MODERATOR
Thread Starter
iTrader: (280)
Join Date: Nov 2006
location: Denton, Texas
Posts: 12,976
Thanked 148 Times in 115 Posts
Quote:
Originally Posted by saywat? View Post
if its an aftermarket motor my warranty exchanged motor from orielys did that. it wasnt failing going up and down just the open door feature. i kept it on for couple of months out of laziness and finally replaced it under the lifetime warranty. these refurb motors are sometimes hit and miss
just saw your response lol!!! Exactly what I was getting at

Related Topics
Thread Thread Starter Forum Replies Last Post
2005 G35 Coupe - Window Problem - Weird leo38cheng G35 Coupe V35 2003 - 07 7 11-12-2015 07:49 PM
WTB: WTB: Driver Window Switch - 05 Coupe leo38cheng Interior 3 08-18-2015 07:30 AM
New window motor, wont roll up ev_g35 Interior 1 08-14-2015 03:05 PM
Drivers side window is not secure. Don't know whats up. will091195 General Tech Questions 1 07-27-2015 10:19 PM
Silver G35 coupe suggestions? Kal Hamm G35 Coupe V35 2003 - 07 2 07-24-2015 09:55 AM


Tags
350z, car, clean, coupe, diy, door, g35, jump, motor, panel, pulling, regulator, remove, tsb, window
Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



All times are GMT -4. The time now is 07:12 PM.


Copyright ©2002 - 2017, rupromenergo.ru All Rights Reserved. We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.

Related pages


bc racing coiloverturtle wax lens restorer kitds2 hidlos angeles window tint lawinfiniti g37 wheelsapexi rsm diagramelectronic beepwiring sub and ampwedssport lug nutssc430 exhaustskyline r34 tail lightskenwood dnx9960jl w0v2how to program a viper remotemk3 supra wheelstein basicssqueaky clutch pedalcarbeau seatsdifferent exhaust soundsinfinity g35 awdra89pac aai-gm24350z forum ukexile subwooferluk flywheel22mm lug nutinfinity hingescars hiccupspennzoil platinum uoamy car alarm goes off randomlyfm radio reception problems2005 infiniti g35xunichip tunervq37vhr swaptsw rims canada2003 wrx sti specshow to remove pinstripingbest lug nut lockswhich hid lights are illegalwhat does a bad knock sensor causeweds kranze cerberuswhat cars can fit a 2jz engineacura tl type s bolt patternm35 0-60difference between single mass and dual mass flywheelmsr 045nexen n5000 plusorlando plasti dipwood grain nardi steering wheelhps intakerubber trim moldingeasiest defensive driving texasjl audio free air subwoofer18x7.5 rimsis300 drivetraincraigslist in redwood city cag35 coupe bumperinfinity g30lexani lx 5 tiresinfiniti g35 side skirtshks filterberk high flow cats 350ztpms light keeps coming ondyrdek fantasy factory locationredrilling wheel bolt patterntemporary tags ncinfinity v35ac receiver drier replacement2jz 6 speed transmissionwhat does vdc off slip meaninfiniti g35 floor mats factoryvw boser hood99 saturn sl2g37s wheelscam chain tensioner replacementauto transmission slippingblue flame tires raleigh nc